SuperVolcano 80W Heater (12V) (E-HEATER-12V-80W-KIT)

These 80W heaters have been designed specifically for the needs of the SuperVolcano HotEnd and provide the much needed power in order to achieve the highest flow rate possible. These have an extra long 47.50mm heater cartridge to fit the fit the geometry of the SuperVolcano block. *The 12V heater is supplied with mosfet as standard. Health and Safety: The 12V SuperVolcano heater draws up to 8A which is more than most controller boards can handle. Therefore it cannot be used without the included mosfet switch which will handle the high current requirement. Do not use the heater provided with any other block than the SuperVolcano block. Using the heater with another block might result in catastrophic failure of the system. Please note care must be taken when bending the heater cartridge wires and not to bend them to a sharp point as this could snap the wires due to their gauge. Ensure not to fatigue the wires by repeatedly bending them as this will cause failure. The full health and safety information can be found in the datasheet and must be adhered to.