High Temperature Heated Beds-200x200mm-110V (E-BED-HT-200-200-110V-KIT)

High temperatures heated beds to be used for printing high temperature plastics or where fast heat-up times are required. Must be used with an SSR to switch and control. ——————————————- Sensor used: 104-GT2 “E3D” thermistor Power: 500W (200×200), 800W (300×200), 1100W (300×300) Max operating temp: 200?C Peak temp: 250?C Heat up time: 80s to 100?C ——————————————- ??WARNINGS?? These things get HOT! – Use appropriate protective equipment when operating a machine using this component. – Runs on mains voltage, it is the user’s resposibility to make sure that the wiring is insulated and compliant with the relevant regulations and that the device is EARTHED (grounded) properly using the threaded hole provided. – During the first heat cycle, due to the high temperature reacheable by the heated beds, some smoke might be generated by the metal plate or heater. This is normal and due to the manufacturing process, but you must make sure that the device is first heated up in a well ventilated area. **Please note, you cannot print directly onto the bed, a glass bed is required** —————————————— 1 x High temperature heated bed 4 x PPS bed spacers 4 x M3x8mm bolts 8 x 3mmID washers