Upgrade kit for Ultimaker
Matchless RACE nozzles except marked as standard (std): 0.25 std- 0.40-0.60-0.80-1.0-1.5-2.0mm,+ legacy (std) 025-040-060-080
Whatˋs this?
– This upgrade significantly decreases printing time. If you can live with a lower resolution in some prints, you can save 75% printing time (4x increase in plastic output), A 16h print (UM2) finishes in 4h (Matchless Upgrade, 1.0mm + RACE nozzle compared to 0.40mm. Needs 35W heater (standard in UM2+).
– 0.40mm Matchless RACE nozzle with BLOCK V3 and 35W will half time or better, 16h print finishes in 8h or faster.
* settings: 0.40 nozzle x 0.3 layer x 150mm/sec = 18 cubic
– 1.0mm Matchless RACE nozzle
* settings: 1.0 x 0.5 x 60 = 30 cubic/sec
– 0.40mm Matchless RACE nozzle with BLOCK V3 and 35W will half time or better, 16h print finishes in 8h or faster.
* settings: 0.40 nozzle x 0.3 layer x 150mm/sec = 18 cubic
– 1.0mm Matchless RACE nozzle
* settings: 1.0 x 0.5 x 60 = 30 cubic/sec
These are minimum results if your UM2+ is correctly configured. You will be able to find your own settings/favourite relation of speed,layer, nozzle and increase from here!
Matchless Nozzles available:
0.10mm – 2.0mm. (worldˋs smallest and largest?)
Hardware needed:
– Totally re-engineered heater block, BLOCK V3
– Re-invented MATCHLESS RACE Nozzles (patents pending)
– 35W heater (standard w/UM2+)
– A UM2/+, of course
– Designed by “Swordriff” and manufactured at an ISO 9001 corp. in Norway
Reviews
There are no reviews yet.